How to Add Cameras Connected to NVR-(Manual)

• Related Articles

• How to add our Push Module to Vivotek Cameras

  Step 1: Connect to the camera. Connect the camera to the network and identify its IP address using Vivotek Installation Wizard. Double click on the camera to open the web interface page in your browser. Step 2: Configure Network settings. Make sure ...

• How to Add Push Module to Tiandy Cameras

  To add a push module to the Tiandy camera please update the camera with the firmware that has a preinstalled push module. Step 1: Download firmware with a preinstalled push module. Navigate to: Tiandy Firmwares with Pre-Installed Push Module in your ...

• How to install Push Module: Axis Cameras

  Almost all Axis cameras can be added using our custom built push module! Depending on the camera's main chip a different version of the push module should be used. To download model-specific push module please visit: Axis Camera Push Module from your ...

• How to Enable ONVIF on Hikvision Cameras

  This guide is based on you knowing the IP address of your Camera. Summary: Enable Onvif on Hikvision cameras: Navigate to the camera IP address – Default IP is 192.168.0.64 Login in to cameras web interface. Go to Configuration -> Network > Advanced ...

• How to Install Push Module: Hikvision Cameras

  Make sure that your camera has the latest firmware! Take note only: R2, R4, R6, G0 and G1 series are supported. For full compatibility chart navigate to: List of Supported Models from your knowledge base If the camera was used before or the factory ...